There was an error signing up for restock notifications. Please try again.
NEW Update: Slight delays on Batch 7 of the Sub Atomic's! no more then an extra week out. Kits are now estimated to be available between 4/26-4/27.
UPDATE - Sub Atomic kits have been slightly updated
Updated Aluminum camera guards are now silver with a bit more curves in the design making them slightly more durable.
Updated rear mounts are a little wider, and now support thicker gauge battery wire leads. With two outlets for the battery leads
Offset tapped holes in the camera mounts to remove the confusion of mounting orientation.
Countersunk stack screws! :D
76mm motor to motor
Dry weight: About 13.25 grams, including stack hardware.
Motor support: 6.6mm and 9mm
40mm prop cap
Nano cam support
Insta360GO compatible W/included mounts
AdditionalFREE .stl Insta360Go mounts (Scroll to the bottom ;)
Cineshot style DC frame
Top mount for a little freestyle
Bottom mount when running an Insta360Go
Native JHEMCU GHF13AIO 16x16 design, to allow for a clean, slammed deck, center of mass sweet spot build! Meaning, we designed the Sub Atomic around and for the JHEMCU GHF13AIO. However, you can just add spacers if you want to run a traditional 16x16 stack.
Aluminum Camera mounts - A Gnarlyfpv FIRST! ;)
HD camera base adapter
Hybrid mini Immortal T mount & Single antenna mount
High quality 3k chamfered carbon
MOTOR SCREWS! Yes :) motor screws included to fit THIS frame. No more guess work.
1x Top plate
1x Bottom plate
1x Precut battery pad
1x Camera adapter base
1x Insta360 GO LITE camera ring
1x Rear mount
2x Aluminum camera mounts
2x Rx antenna mounts
4x Arm skids
3x M2x6 Button screws (HD camera base/Ring screws)
6x M2x5 countersunk screws
4x M2x10 Button stack screws
5x M2 Steel nuts
4x M2 Nylon nuts
4x M2 Rubber dampeners
12x M1.4 motor screws
8x M2x4 Button motor screws
2x M2x4 Button camera mounting screws
There was a mix up on our end with the layout of the battery pads.. This resulted in the battery pads being cut mirrored to what they needed to be. The pads will still work as a battery pad! They just look a little goofy on the center cutouts! Your batteries will cover this anyway, if you top mount. ALSO, the stack screws we received were not countersunk like they needed to be! So stack screws will be button head until we can order the correct screw. The fix will come on the next batch. Sorry for the mix ups!